LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> Ascender RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 274 (Automatic Transmission - 4L60-E/4L65-E/4L70-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> Repair Instructions - Off Vehicle >> Input Carrier Inspection

Input Carrier Inspection

WARNING: This page is about a different car, the 2008 Isuzu Ascender, 2008 GMC Envoy, and 2008 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Input Carrier Pinion End Play Measurements
    GM735074Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Check end play on each pinion. Clearance is the same for 4 or 5 pinion design.
  1. Check the input carrier pinion end play. The end play must not exceed 0.61 mm (0.024 in).
  2. Inspect the input carrier for pinion gear damage, proper pin stake and keystoned pinion gears. Pinions must rotate freely.
scientia non olet · About LEMON Manuals