LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> Ascender RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 274 (Automatic Transmission - 4L60-E/4L65-E/4L70-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> Repair Instructions - Off Vehicle >> Input Carrier Inspection & Installation >> Tool Required >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Isuzu Ascender, 2008 GMC Envoy, and 2008 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Input Carrier Captive Thrust Bearing Assembly
    GM5463Courtesy of GENERAL MOTORS CORP.
  1. Inspect the input carrier captive thrust bearing assembly. To check the captive thrust bearing in the input carrier (662) for wear, place a bushing or an output shaft sleeve (690) onto the bearing race and turn it with the palm of your hand. Do not touch the pinion gears. Any imperfections will be felt through the bushing.
    2. Fig 2: View Of Input Carrier & Thrust Bearing Assembly
    GM1960168Courtesy of GENERAL MOTORS CORP.
  2. Install the thrust bearing assembly (663) on the input carrier (662). Retain bearing with J 36850  . See Special Tools .
  3. Install the input carrier assembly (662) onto the output shaft. The carrier assembly can be either a 4 or 5 pinion design, depending on model.
    4. Fig 3: View Of Output Shaft To Input Carrier Retainer
    GM13271Courtesy of GENERAL MOTORS CORP.
    IMPORTANT:
    • Do not reuse the old output shaft to input carrier retainer (661).
    • Do not over expand the new output shaft to input carrier retainer during installation.
  4. Install a new output shaft to input carrier retainer (661).
    5. Fig 4: Identifying J 29837-A
    GM588767Courtesy of GENERAL MOTORS CORP.
  5. Remove the J 29837-A  . See Special Tools .
scientia non olet · About LEMON Manuals