LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> Ascender RWD >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> Bolted Exterior Body Panels And Closures >> Repair Instructions >> Rear Side Door Wiring Harness Replacement >> Removal Procedure

Removal Procedure

  1. Remove the door trim panel. Refer to Rear Side Door Trim Panel Replacement .
  2. Remove the water deflector. Refer to Rear Side Door Water Deflector Replacement .
  3. Remove the speaker. Refer to Radio Rear Side Door Speaker Replacement .
  4. Disconnect the regulator motor electrical connector.
  5. Disconnect the door latch assembly electrical connector.
  6. Remove the second pillar trim. Refer to Center Pillar Garnish Molding Replacement .
    7. Fig 1: Identifying Rubber Conduit Retainer
    GM735198Courtesy of GENERAL MOTORS CORP.
  7. From the inside of the door, release the rubber conduit retainer from the door by releasing the retaining tabs.
  8. Using the pillar access hole, remove the door harness connector retainer from the second pillar by releasing the retaining tabs.
  9. Disconnect the 6-way and the 8-way electrical connectors from the door wire harness connector.
    10. Fig 2: Identifying Rear Door Wiring Harness
    GM735197Courtesy of GENERAL MOTORS CORP.
  10. Note the routing of the wire harness and release the wire harness attachments from the door.
  11. Remove the wire harness from the door.
scientia non olet · About LEMON Manuals