LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> Ascender RWD >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> Bolted Exterior Body Panels And Closures >> Repair Instructions >> Rear Side Door Replacement >> Removal Procedure

Removal Procedure

  1. Remove the power window switch. Refer to Rear Side Door Window Switch Replacement .
  2. Remove the trim panel. Refer to Rear Side Door Trim Panel Replacement .
  3. Remove the inner window belt sealing strip. Refer to Sealing Strip Replacement - Rear Door Window Belt Inner .
  4. Remove the outer window belt sealing strip. Refer to Sealing Strip Replacement - Rear Door Window Belt Outer .
  5. Remove the upper sealing strip. Refer to Rear Door Upper Sealing Strip Replacement .
  6. Remove the inside release handle. Refer to Door Inside Handle Replacement .
  7. Remove the water deflector. Refer to Rear Side Door Water Deflector Replacement .
  8. Remove the speaker. Refer to Radio Rear Side Door Speaker Replacement .
  9. Remove the window. Refer to Rear Side Door Window Replacement .
  10. Remove the stationary window and run channel assembly. Refer to Rear Side Door Window Channel Replacement .
  11. Remove the window regulator. Refer to Rear Side Door Window Regulator Replacement .
  12. Remove the door latch assembly. Refer to Rear Door Latch Replacement .
  13. Remove the outside door handle. Refer to Door Handle Replacement - Rear Outside .
  14. Remove the check link. Refer to Door Check Link Replacement .
  15. Remove the wire harness from the door. Refer to Rear Side Door Wiring Harness Replacement .
    16. Fig 1: Identifying Door To Hinge Plate Bolts
    GM723025Courtesy of GENERAL MOTORS CORP.
  16. Remove the bolts that retain the door to the hinge plates.
  17. Remove the door from the vehicle with an assistant.
scientia non olet · About LEMON Manuals