LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> Ascender RWD >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> Bolted Exterior Body Panels And Closures >> Repair Instructions >> Liftgate Wiring Harness Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Identifying Liftgate Wiring Harness
    GM749974Courtesy of GENERAL MOTORS CORP.
  1. Install the wiring harness to the liftgate as previously routed. Ensure that the harness retainers are fully seated.
    2. Fig 2: Identifying Liftgate Power Lock Assembly Connectors
    GM749977Courtesy of GENERAL MOTORS CORP.
  2. Connect the 2 liftgate power lock assembly connectors (1,3).
    3. Fig 3: Identifying License Plate Lamp Connector & Liftgate Window Latch Connector
    GM749972Courtesy of GENERAL MOTORS CORP.
  3. Connect the rear windshield wiper motor connector (1).
  4. Connect the liftgate window latch connector.
    5. Fig 4: Locating Liftgate Module Electrical Connectors
    GM749979Courtesy of GENERAL MOTORS CORP.
  5. Connect the license plate lamp connector (1).
  6. Connect the electrical connectors (3) from the liftgate module.
    7. Fig 5: View Of Liftgate Window Handle Bolts And Defogger Grid Electrical Connectors
    GM698542Courtesy of GENERAL MOTORS CORP.
  7. Connect the rear windshield defogger connectors (2).
    8. Fig 6: Identifying Wiring Harness Pass Through Boot To Liftgate
    GM749976Courtesy of GENERAL MOTORS CORP.
  8. Connect the rear washer fluid supply line.
  9. Connect the liftgate wiring harness inline connector.
  10. Install the wiring harness passthrough boot to the liftgate.
  11. Install the liftgate trim panel. Refer to Liftgate Trim Panel Replacement .
  12. Install the liftgate window garnish molding. Refer to Rear Window Garnish Molding Replacement .
scientia non olet · About LEMON Manuals