LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> Ascender RWD >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> Bolted Exterior Body Panels And Closures >> Repair Instructions >> Liftgate Replacement >> Installation Procedure

Installation Procedure

    Fig 1: View Of Liftgate Hinge & Nuts
    GM721409Courtesy of GENERAL MOTORS CORP.
  1. Install the liftgate to the vehicle with the aid of an assistant.
  2. NOTE: Refer to FASTENER NOTICE .
  3. Install the liftgate hinge nuts.

    Tighten:  Tighten the liftgate hinge nuts to 20 N.m (15 lb ft).

  4. Install the liftgate struts. Refer to Liftgate Strut Replacement .
  5. Install the wire harness to the liftgate. Refer to Liftgate Wiring Harness Replacement .
  6. Install the liftgate control module. Refer to Liftgate Control Module Replacement .
  7. Install the window wiper assembly. Refer to Washer Hose Replacement - Rear (TrailBlazer, Envoy) .
  8. Install the window latch assembly. Refer to Liftgate Window Latch Replacement .
  9. Install the lock cylinder. Refer to Liftgate Lock Cylinder Replacement .
  10. Install the license plate pocket. Refer to Rear License Plate Pocket Replacement .
  11. Fig 2: View Of Liftgate Window Handle Bolts And Defogger Grid Electrical Connectors
    GM698542Courtesy of GENERAL MOTORS CORP.
  12. Connect the rear windshield defogger electrical connectors (2).
  13. Fig 3: Identifying Wiring Harness Pass Through Boot To Liftgate
    GM749976Courtesy of GENERAL MOTORS CORP.
  14. Connect the rear window washer fluid supply hose.
  15. Connect the CHMSL electrical connector behind the header panel.
  16. Install the liftgate trim panel. Refer to Liftgate Trim Panel Replacement .
  17. Install the liftgate window garnish molding. Refer to Rear Window Garnish Molding Replacement .
  18. Install the upper rear quarter trim, located above the tail lamp. Refer to Rear Panel Molding Replacement .
  19. Install the liftgate window. Refer to Liftgate Window Replacement .