LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> Ascender RWD >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> Bolted Exterior Body Panels And Closures >> Repair Instructions >> Liftgate Latch Replacement >> Removal Procedure

Removal Procedure

  1. Remove the liftgate window garnish molding. Refer to Rear Window Garnish Molding Replacement .
  2. Remove the liftgate trim panel. Refer to Liftgate Trim Panel Replacement .
    3. Fig 1: Identifying Bellcrank Rod To Outside Door Release Handle
    GM721381Courtesy of GENERAL MOTORS CORP.
  3. Disconnect the outside handle rod from the bellcrank.
    4. Fig 2: Identifying Bellcrank From The Latch/Lock & Retaining Screws
    GM721388Courtesy of GENERAL MOTORS CORP.
  4. Disconnect the bellcrank rod from the latch/lock assembly.
  5. Remove the screws that retain the bellcrank to the latch/lock.
  6. Remove the bellcrank from the latch/lock.
    7. Fig 3: Identifying Lock Cylinder Bellcrank Rod
    GM721383Courtesy of GENERAL MOTORS CORP.
  7. Disconnect the electrical connector from the latch assembly.
  8. Disconnect the lock cylinder bellcrank rod (1) from the latch assembly.
  9. Remove the screws that retain the latch/lock assembly to the liftgate.
  10. Remove the latch/lock assembly from the liftgate.
scientia non olet · About LEMON Manuals