LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> Ascender RWD >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> Bolted Exterior Body Panels And Closures >> Repair Instructions >> Liftgate Latch Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Identifying Lock Cylinder Bellcrank Rod
    GM721383Courtesy of GENERAL MOTORS CORP.
  1. Position the latch/lock assembly to the liftgate.
    2. NOTE: Refer to FASTENER NOTICE .
  2. Install the screws that retain the latch/lock assembly to the liftgate.

    Tighten:  Tighten the screws to 10 N.m (89 lb in).

  3. Connect the lock cylinder bellcrank rod (1) to the latch/lock assembly.
  4. Connect the electrical connector to the latch/lock assembly.
    5. Fig 2: Identifying Bellcrank From The Latch/Lock & Retaining Screws
    GM721388Courtesy of GENERAL MOTORS CORP.
  5. Position the bellcrank to the latch/lock assembly.
  6. Install the screws that retain the bellcrank to the latch/lock assembly.

    Tighten:  Tighten the screws to 0.7 N.m (6 lb in).

  7. Connect the bellcrank rod to the latch/lock assembly.
    8. Fig 3: Identifying Bellcrank Rod To Outside Door Release Handle
    GM721381Courtesy of GENERAL MOTORS CORP.
  8. Connect the outside handle rod to the bellcrank.
  9. Install the liftgate trim panel. Refer to Liftgate Trim Panel Replacement .
  10. Install the liftgate window garnish molding. Refer to Rear Window Garnish Molding Replacement .
scientia non olet · About LEMON Manuals