LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> Ascender RWD >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> Bolted Exterior Body Panels And Closures >> Repair Instructions >> Liftgate Hinge Replacement >> Removal Procedure

Removal Procedure

  1. Remove the liftgate window. Refer to Liftgate Window Replacement .
  2. Remove the liftgate struts. Refer to Liftgate Strut Replacement .
  3. Disconnect the liftgate to body wiring harness connector. Refer to Liftgate Wiring Harness Replacement .
    4. Fig 1: Identifying Liftgate Hinge Pivot Retainers
    GM1344407Courtesy of GENERAL MOTORS CORP.
  4. Remove the liftgate hinge pivot retainers (1) from the liftgate hinge pivots.
  5. With the aid of an assistant, remove the liftgate from the body side hinge by sliding the liftgate to the left disengaging the hinge pivots from the bushings.
  6. Place the liftgate on a clean, protected surface.
    7. Fig 2: Identifying Liftgate Hinge Bushings & Pivots
    GM1344405Courtesy of GENERAL MOTORS CORP.
  7. Remove the liftgate hinge bushings (1) from the liftgate hinges.
  8. Remove the lift hinge pivots (2) from the liftgate hinges.
    9. Fig 3: Identifying Body Side Hinge Pivots & Bushings
    GM1344406Courtesy of GENERAL MOTORS CORP.
  9. Remove the hinge pivots (1) from the body side hinges.
  10. Remove the hinge bushings (2) from the body side hinges.
    11. Fig 4: Identifying Body Side Hinge Retaining Nuts
    GM1344402Courtesy of GENERAL MOTORS CORP.
  11. Remove the nuts retaining the body side hinges (1) to the body.
  12. Remove the body side hinges from the body.
scientia non olet · About LEMON Manuals