LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> Ascender RWD >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> Bolted Exterior Body Panels And Closures >> Repair Instructions >> Hood Rear Seal Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Locating Air Inlet Grille Panel/Hood Seal
    GM742164Courtesy of GENERAL MOTORS CORP.
  1. Position the seal to the air inlet grille panel.
  2. Install the rear hood seal to the air inlet grille panel studs.
  3. Close the hood.
scientia non olet · About LEMON Manuals