LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> Ascender RWD >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> Bolted Exterior Body Panels And Closures >> Repair Instructions >> Hood Latch Replacement >> Installation Procedure

Installation Procedure

    Fig 1: View Of Hood Latch Cable To Latch
    GM742161Courtesy of GENERAL MOTORS CORP.
  1. Connect the hood latch cable to the latch.
    2. Fig 2: Identifying Hood Latch-To-Support Bracket Bolts
    GM749964Courtesy of GENERAL MOTORS CORP.
  2. Position the latch to the previously marked location on the mounting bracket.
    3. NOTE: Refer to FASTENER NOTICE .
  3. Install the bolts which retain the latch to the mounting bracket.

    Tighten:  Tighten the bolts to 10 N.m (89 lb in).

  4. Inspect the latch for proper operation before closing the hood.
  5. Check the alignment of the latch to the hood striker. Adjust the latch, if necessary. Refer to Hood Latch Adjustment .
  6. Install the grille. Refer to Grille Replacement (Envoy) , Grille Replacement (Rainier) or Grille Replacement (TrailBlazer) .
scientia non olet · About LEMON Manuals