LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> Ascender RWD >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> Bolted Exterior Body Panels And Closures >> Repair Instructions >> Front Side Door Replacement >> Removal Procedure

Removal Procedure

  1. Disable the supplemental inflatable restraint (SIR) system. Refer to SIR Disabling and Enabling and to SIR Disabling and Enabling .
  2. Remove the accessory switch panel. Refer to Door Lock and Side Window Switch Replacement - Driver .
  3. Remove the door trim panel. Refer to Front Side Door Trim Panel Replacement .
  4. Remove the outer belt sealing strip. Refer to Sealing Strip Replacement - Front Door Window Belt Outer .
  5. Remove the inside door handle. Refer to Door Inside Handle Replacement .
  6. Remove the speaker. Refer to Radio Front Side Door Speaker Replacement .
  7. Remove the water deflector. Refer to Front Side Door Water Deflector Replacement .
  8. Remove the outside rear view mirror (ORVM). Refer to Mirror Replacement .
  9. Remove the window. Refer to Front Side Door Window Replacement .
  10. Remove the weatherstrip run channel. Refer to Front Side Door Window Channel Replacement .
  11. Remove the window regulator. Refer to Front Side Door Window Regulator Replacement .
  12. Remove the door latch assembly. Refer to Front Side Door Latch Replacement .
  13. Remove the side door SIR sensor. Refer to Inflatable Restraint Side Impact Sensor Replacement .
  14. Remove the outside door handle. Refer to Door Handle Replacement - Front Outside .
  15. Remove the check link. Refer to Door Check Link Replacement .
  16. Remove the wire harness from the door. Refer to Front Side Door Wiring Harness Replacement .
    17. Fig 1: Identifying Door To Hinge Plate Bolts
    GM723025Courtesy of GENERAL MOTORS CORP.
  17. Remove the bolts that retain the door to the hinge plates.
  18. Remove the door from the vehicle with an assistant.
scientia non olet · About LEMON Manuals