LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> Ascender RWD >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Panel System Displays And Gauges >> Diagnostic Information and Procedures >> Engine Oil Pressure Gage Inaccurate or Inoperative (4.2L) >> Circuit/System Testing

Circuit/System Testing

  1. Ignition OFF, disconnect the EOP switch.
  2. Ignition ON, verify the scan tool Engine Oil Pressure Switch parameter is OK.
    • If not OK, test the signal circuit of the EOP switch for a short to ground. If the circuit tests normal replace the PCM.
  3. Ignition ON, perform the engine oil gage sweep test with the scan tool.
    • If the engine oil pressure gage does not sweep from its low to high position, replace the IPC.
  4. If all circuits test normal, test or replace the EOP switch.
scientia non olet · About LEMON Manuals