Removal Procedure

Fig 1: Side View Of Tyco/AMP Connector

Courtesy of GENERAL MOTORS CORP.

Side view of connector.

Fig 2: Top View Of Tyco/AMP Connector

Courtesy of GENERAL MOTORS CORP.

View of top of connector.

1. Locate the assist lever and lock on the top of the connector.
Fig 3: View Of Depressing Lock & Pulling Assist Lever
Courtesy of GENERAL MOTORS CORP.
2. While depressing the lock, pull the lever over and past the lock.
Fig 4: View Of Component Connector
Courtesy of GENERAL MOTORS CORP.
3. Disconnect the connector from the component.
Fig 5: Identifying Locking Tabs
Courtesy of GENERAL MOTORS CORP.
4. Locate the dress cover locking tabs at the rear of the connector. Use a small flat-blade tool to release the locking tabs. Repeat this procedure for the other locking tab.
Fig 6: View Of Inner Connector & Connector Housing
Courtesy of GENERAL MOTORS CORP.
5. Once the locking tabs are unlocked, slide the inner connector out of the rear of the connector housing.
Fig 7: View Of Terminal Release Tool
Courtesy of GENERAL MOTORS CORP.
6. Use the J 38125-12A (GM P/N 12094429) tool to release the terminals by pressing on the tang. See the release tool cross reference in the Reference Guide of the J-38125  to ensure that the correct release tool is used. See Special Tools .
7. While holding the removal tool in place, gently pull the wire out of the back of the connector. Always remember never use force when pulling a terminal out of a connector.