LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> Ascender RWD >> Repair and Diagnosis (Single Page) >> Body & Frame >> Exterior/Interior Trim >> Seat Hardware, Seat Trim, And Upholstery >> Repair Instructions >> Seat Cushion Trim Panel Replacement - Rear No. 1 (TrailBlazer EXT, Envoy XL) >> Installation Procedure

Installation Procedure

    Fig 1: Locating Seat Cushion Trim Panel To Seat Frame Screws
    GM828146Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  1. Install the screws securing the seat cushion trim panel to the seat cushion assembly.

    Tighten:  Tighten the rear seat cushion trim panel screws to 2 N.m (18 lb in).

    2. Fig 2: Identifying Seat Cover J Strips
    GM828226Courtesy of GENERAL MOTORS CORP.
  2. Install the seat cover J-strips (1) to the seat cushion trim panel (2).
    3. Fig 3: Identifying Seat Cushion Trim Panel Support & Bolts
    GM828229Courtesy of GENERAL MOTORS CORP.
  3. Install the 2 bolts (2) securing the support (1) to the seat cushion trim panel.

    Tighten:  Tighten the rear seat support bolts to 35 N.m (26 lb ft).

    4. Fig 4: Locating Rear Seat Bracket Trim Covers & Mounting Nuts
    GM828144Courtesy of GENERAL MOTORS CORP.
  4. Install the rear seat bracket with the 4 mounting nuts (2).

    Tighten:  Tighten the rear seat bracket mounting nuts to 25 N.m (18 lb ft).

  5. Install the rear seat bracket trim covers (1).
  6. Install the seat in the vehicle. Refer to Rear Seat Replacement .
scientia non olet · About LEMON Manuals