LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> Ascender RWD >> Repair and Diagnosis (Single Page) >> Body & Frame >> Exterior/Interior Trim >> Seat Hardware, Seat Trim, And Upholstery >> Repair Instructions >> Seat Cushion Replacement - Rear No. 1 (TrailBlazer, Envoy, Rainier) >> Removal Procedure

Removal Procedure

  1. Remove the rear seat bracket trim cover.
  2. Remove the hydraulic jack from the jack stowage area, on the left side only.
    3. Fig 1: View Of Seat Cushion Assembly
    GM722615Courtesy of GENERAL MOTORS CORP.
  3. Position the seat cushion assembly in order to gain access to the 2 rear seat mounting nuts.
  4. Remove the 2 mounting nuts.
  5. Remove the seat cushion assembly from the vehicle.
scientia non olet · About LEMON Manuals