LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> Ascender RWD >> Repair and Diagnosis (Single Page) >> Body & Frame >> Exterior/Interior Trim >> Seat Hardware, Seat Trim, And Upholstery >> Repair Instructions >> Seat Cushion Replacement - Rear No. 1 (TrailBlazer, Envoy, Rainier) >> Installation Procedure

Installation Procedure

    Fig 1: View Of Seat Cushion Assembly
    GM722615Courtesy of GENERAL MOTORS CORP.
  1. Position the seat cushion assembly to the vehicle.
    2. NOTE: Refer to Fastener Notice .
  2. Install the 2 nuts that retain the seat cushion assembly to the floor panel.

    Tighten:  Tighten the rear seat mounting nuts to 45 N.m (33 lb ft).

  3. Install the hydraulic jack into the jack stowage area, on the left side only.
  4. Adjust the seat cushion assembly to the latched position.
  5. Install the rear mount trim cover.
scientia non olet · About LEMON Manuals