LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> Ascender RWD >> Repair and Diagnosis (Single Page) >> Body & Frame >> Exterior/Interior Trim >> Seat Hardware, Seat Trim, And Upholstery >> Repair Instructions >> Seat Cushion Pull Strap Replacement - Rear No. 1 (TrailBlazer, Envoy, Rainier) >> Installation Procedure

Installation Procedure

    Fig 1: View Of Rear Seat Cushion Latch & Strap
    GM753718Courtesy of GENERAL MOTORS CORP.
  1. Install the small loop (1) onto the rear seat cushion latch (2).
    2. Fig 2: View of Rear Seat Cushion Latch
    GM753717Courtesy of GENERAL MOTORS CORP.
  2. Install the strap through the opening in the seat pan.
  3. Install the rear-seat cushion cover and the pad. Refer to Seat Cushion Cover and Pad Replacement - Rear No. 1 .
  4. Install the rear seat cushion assembly to the vehicle. Refer to Seat Cushion Replacement - Rear No. 1 (TrailBlazer, Envoy, Rainier) .
scientia non olet · About LEMON Manuals