LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> Ascender RWD >> Repair and Diagnosis (Single Page) >> Body & Frame >> Exterior/Interior Trim >> Seat Hardware, Seat Trim, And Upholstery >> Repair Instructions >> Seat Cushion Outer Trim Panel Replacement >> Removal Procedure

Removal Procedure

  1. Remove the trim panel from the power seat by performing the following:
    1. Remove the 3 seat switch bezel mounting screws. Refer to Seat Switch Bezel Replacement .
      2. Fig 1: View Of Trim Panel Retaining Screws Removed (Right)
      GM752954Courtesy of GENERAL MOTORS CORP.
    2. Remove the 3 trim panel retaining screws.
  2. Remove the trim panel from the manual seat by performing the following steps:
    1. Remove the lumbar support knob. Refer to Lumbar Support Knob Replacement .
    2. Remove the seat back recliner handle. Refer to Seat Back Recliner Handle Replacement - Front .
      3. Fig 2: View Of Trim Panel Retaining Screws Removed (Left)
      GM755843Courtesy of GENERAL MOTORS CORP.
    3. Remove the screws from the trim panel.
  3. Remove the trim panel from the seat assembly.
scientia non olet · About LEMON Manuals