LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> Ascender RWD >> Repair and Diagnosis (Single Page) >> Body & Frame >> Exterior/Interior Trim >> Seat Hardware, Seat Trim, And Upholstery >> Repair Instructions >> Seat Cushion Latch Release Assembly Replacement - Rear No. 1 (TrailBlazer, Envoy, Rainier) >> Installation Procedure

Installation Procedure

    Fig 1: View of Rear Seat Cushion Latch
    GM753717Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  1. Install the 3 bolts securing the rear seat cushion latch to the seat pan.

    Tighten:  Tighten the rear seat cushion latch release bolts to 10 N.m (88 lb in).

    2. Fig 2: View Of Rear Seat Cushion Latch & Strap
    GM753718Courtesy of GENERAL MOTORS CORP.
  2. Install the small loop (1) onto the rear seat cushion latch (2).
  3. Install the strap through the opening in the seat pan.
  4. Install the rear seat cushion cover and the pad. Refer to Seat Cushion Cover and Pad Replacement - Rear No. 1 .
  5. Install the rear seat cushion assembly to the vehicle. Refer to Seat Cushion Replacement - Rear No. 1 (TrailBlazer, Envoy, Rainier) .
scientia non olet · About LEMON Manuals