LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> Ascender RWD >> Repair and Diagnosis (Single Page) >> Body & Frame >> Exterior/Interior Trim >> Seat Hardware, Seat Trim, And Upholstery >> Repair Instructions >> Seat Cushion Cover and Pad Replacement - Rear No. 1 >> Installation Procedure

Installation Procedure

  1. Install the cover to the cushion.
  2. Install the reinforcement bar to the hog-rings.
  3. Attach the retaining strips that retain the cover to the cushion.
  4. In order to install the seat cushion to the seat pan, perform the following:
  5. Install the seat pan to the cushion and cover assembly.
  6. Compress the foam and install the seat cover and cushion to the seat pan.
    7. Fig 1: View of Seat Cover J Strips
    GM753722Courtesy of GENERAL MOTORS CORP.
  7. Connect the J-strips that retain the cover to the seat pan.
    8. Fig 2: Identifying Seat Bottom Push Pins
    GM753710Courtesy of GENERAL MOTORS CORP.
  8. Install the push pins (1) on the underside of the seat bottom.
    9. Fig 3: Locating Seat Latch Bezel
    GM753715Courtesy of GENERAL MOTORS CORP.
  9. Install the latch bezels.
  10. Install the seat cushion bracket. Refer to Seat Cushion Bracket Replacement - Rear No. 1 .
  11. Install the seat cushion in the vehicle. Refer to Seat Cushion Replacement - Rear No. 1 (TrailBlazer, Envoy, Rainier) .
scientia non olet · About LEMON Manuals