Removal Procedure
- Remove the 3 seat switch bezel screws. Refer to Seat Switch Bezel Replacement .
- Remove the 4 nuts that retain the seat pan to the seat adjuster assembly.
- Remove the clip from the front outboard seat pan stud, if equipped. Discard the clip.
- Release the J-strips (1, 3) on each side of the seat cushion.
- Release the front/rear J-strips (2, 4).
- Remove the supplemental inflatable restraint (SIR) electrical harness (2) from the seat pan.
- Remove the seat electrical harness from the seat pan.
- Remove the wire harness fasteners from the seat pan.
- Disconnect the seat cushion heater electrical connector, if equipped.
- Separate the hook and loop retaining strips.
- Remove the hog rings (1) from the bottom rear side of the cover.
- Remove the 11 hog rings from the top side of the cover.
- Remove the seat cushion trim cover and pad from the seat frame.
- Remove the seat module retaining screw, if equipped.
- Remove the seat module, if equipped.
- Remove the seat cover from the seat cushion.
- Remove the seat cushion from the seat pan.
IMPORTANT:
When separating the seat cover hook and loop retaining strips, do not pull the adhesive-backed strip from the seat pad.