LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> Ascender RWD >> Repair and Diagnosis (Single Page) >> Body & Frame >> Exterior/Interior Trim >> Seat Hardware, Seat Trim, And Upholstery >> Repair Instructions >> Seat Cushion Cover and Pad Replacement - Front >> Installation Procedure

Installation Procedure

  1. Install the seat cushion to the seat pan.
  2. Install the seat cover to the seat cushion.
  3. Using a side-to-side motion, carefully pull the seat cushion cover onto the seat pan.
    4. Fig 1: Locating Seat Module Retaining Screw
    GM752957Courtesy of GENERAL MOTORS CORP.
  4. Install the seat module, if equipped.
    5. NOTE: Refer to Fastener Notice .
  5. Install the seat module retaining screw.

    Tighten:  Tighten the screw to 5 N.m (44 lb in).

  6. Install the 11 hog rings to the top side of the cover and pad.
    7. Fig 2: Identifying Bottom Rear Side Hog Rings
    GM752959Courtesy of GENERAL MOTORS CORP.
  7. Install the 2 hog rings (1) to the bottom rear side of the cover and pad.
  8. Press the seat cover hook and loop retaining strips together by running your hand firmly over the seat cover.
    9. Fig 3: Identifying Connectors & Harness
    GM752865Courtesy of GENERAL MOTORS CORP.
  9. Connect the seat cushion heater electrical connector.
  10. Install the seat electrical harness to the seat pan.
  11. Install the SIR electrical harness (2) to the seat pan.
    12. Fig 4: Identifying Side J Strips And Front/Rear J Strips
    GM752956Courtesy of GENERAL MOTORS CORP.
  12. Install the front/rear J-strips (2, 4).
  13. Install the side J-strips (1, 3).
    14. Fig 5: View Of Underside Of Seat Adjuster Frame & Mounting Nuts
    GM752864Courtesy of GENERAL MOTORS CORP.
  14. Install the seat pan to the seat adjuster frame.
  15. Install the 4 retaining nuts to the studs on the underside of the cushion.

    Tighten:  Tighten the nuts to 25 N.m (18 lb ft).

  16. Install the 3 seat switch bezel screws. Refer to Seat Switch Bezel Replacement .
scientia non olet · About LEMON Manuals