LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> Ascender RWD >> Repair and Diagnosis (Single Page) >> Body & Frame >> Exterior/Interior Trim >> Seat Hardware, Seat Trim, And Upholstery >> Repair Instructions >> Seat Cushion Bracket Replacement - Rear No. 1 >> Installation Procedure

Installation Procedure

    Fig 1: View Of Bracket Assembly On Seat Cushion
    GM753711Courtesy of GENERAL MOTORS CORP.
  1. Position the bracket assembly on the seat cushion.
    2. Fig 2: View Of Seat Cushion Bracket Assembly
    GM753713Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  2. Install the 2 bolts securing the bracket assembly to the seat cushion.

    Tighten:  Tighten the rear seat cushion bracket bolts to 25 N.m (18 lb ft).

  3. Install the rear seat cushion assembly in the vehicle. Refer to Seat Cushion Replacement - Rear No. 1 (TrailBlazer, Envoy, Rainier) .
scientia non olet · About LEMON Manuals