LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> Ascender RWD >> Repair and Diagnosis (Single Page) >> Body & Frame >> Exterior/Interior Trim >> Seat Hardware, Seat Trim, And Upholstery >> Repair Instructions >> Seat Back Release Latch Replacement - Rear No. 1 >> Removal Procedure

Removal Procedure

  1. Remove the seat back cover and pad. Refer to Seat Back Cover and Pad Replacement - Rear No. 1 .
    2. Fig 1: Compressing Lower Locking Tabs On Release Latch
    GM753536Courtesy of GENERAL MOTORS CORP.
  2. Remove the release latch by pinching the lower locking tabs together.
    3. Fig 2: Locating Release Cable At Release Latch
    GM753552Courtesy of GENERAL MOTORS CORP.
  3. Remove the release cable from the release latch.
scientia non olet · About LEMON Manuals