LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> Ascender RWD >> Repair and Diagnosis (Single Page) >> Body & Frame >> Exterior/Interior Trim >> Seat Hardware, Seat Trim, And Upholstery >> Repair Instructions >> Seat Back Hinge Replacement - Rear No. 1 >> Removal Procedure

Removal Procedure

  1. Partially remove the seat back cover and pad. Refer to Seat Back Cover and Pad Replacement - Rear No. 1 .
    2. Fig 1: View Of Latch Release Cable & Head Rest Restraint Cable
    GM753531Courtesy of GENERAL MOTORS CORP.
  2. Remove the latch release cables (1) from the latch release mechanism, located at the bottom of the seat back frame.
  3. Remove the head restraint release cable (2) from the left hand hinge bracket.
    4. Fig 2: Identifying Hinge Bracket Bolts
    GM753533Courtesy of GENERAL MOTORS CORP.
  4. Remove the bolts (2) that retain the latch bracket to the hinge bracket.
  5. Remove the bolts (1) that retain the hinge bracket to the seat back frame.
  6. Remove the hinge bracket from the seat back frame.
scientia non olet · About LEMON Manuals