LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> Ascender RWD >> Repair and Diagnosis (Single Page) >> Body & Frame >> Exterior/Interior Trim >> Seat Hardware, Seat Trim, And Upholstery >> Repair Instructions >> Seat Back Hinge Replacement - Rear No. 1 >> Installation Procedure

Installation Procedure

  1. Position the hinge bracket to the seat back frame.
    2. Fig 1: Identifying Hinge Bracket Bolts
    GM753533Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  2. Install the hinge bracket to the seat back frame with 2 bolts (1).

    Tighten:  Tighten the seat back hinge bolts to 35 N.m (26 lb ft).

  3. Install the latch bracket to the hinge bracket with 2 bolts (2).

    Tighten:  Tighten the seat back hinge bolts to 35 N.m (26 lb ft).

    4. Fig 2: View Of Latch Release Cable & Head Rest Restraint Cable
    GM753531Courtesy of GENERAL MOTORS CORP.
  4. Install the latch release cables (1) to the latch release mechanism, located at the bottom of the seat back frame.
  5. Install the head restraint release cable (2) the left hand hinge bracket.
  6. Install the seat back cover and pad. Refer to Seat Back Cover and Pad Replacement - Rear No. 1 .
scientia non olet · About LEMON Manuals