LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> Ascender RWD >> Repair and Diagnosis (Single Page) >> Body & Frame >> Exterior/Interior Trim >> Seat Hardware, Seat Trim, And Upholstery >> Repair Instructions >> Seat Back Hinge Cover Replacement - Rear No. 1 >> Installation Procedure

Installation Procedure

  1. Install the inboard/outboard rear seat back hinge cover halves around the seat back hinges.
    2. Fig 1: Identifying Seat Belt Side Buckle & Retaining Nut
    GM828140Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  2. Install the inboard/outboard rear seat back hinge cover screws.

    Tighten:  Tighten the rear seat back hinge cover screws to 2 N.m (18 lb in).

scientia non olet · About LEMON Manuals