LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> Ascender RWD >> Repair and Diagnosis (Single Page) >> Body & Frame >> Exterior/Interior Trim >> Seat Hardware, Seat Trim, And Upholstery >> Repair Instructions >> Seat Back Frame Replacement - Rear No. 1 >> Removal Procedure

Removal Procedure

  1. Remove the seat back cover and pad. Refer to Seat Back Cover and Pad Replacement - Rear No. 1 .
  2. Remove the latch release assembly. Refer to Seat Back Release Latch Replacement - Rear No. 1 .
  3. Remove the head restraint retractor assembly. Refer to Head Restraint Retractor Assembly Replacement - Rear No. 1 .
  4. Remove the seat back hinge brackets. Refer to Seat Back Hinge Replacement - Rear No. 1 .
  5. Remove the seat belt retractor assembly, on the left side only. Refer to Seat Belt Retractor Replacement - No. 1 Center Rear .
    6. Fig 1: View Of Latch Release Cable & Head Rest Restraint Cable
    GM753531Courtesy of GENERAL MOTORS CORP.
  6. Remove the latch release cable (1) and the head rest restraint cable (2) from the left-hand hinge bracket.
    7. Fig 2: Locating Latch Release Cables On Right-Hand Bracket
    GM753544Courtesy of GENERAL MOTORS CORP.
  7. Remove the latch release cables from the right-hand hinge bracket.
scientia non olet · About LEMON Manuals