LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> Ascender RWD >> Repair and Diagnosis (Single Page) >> Body & Frame >> Exterior/Interior Trim >> Seat Hardware, Seat Trim, And Upholstery >> Repair Instructions >> Seat Back Cover and Pad Replacement - Rear No. 1 >> Removal Procedure

Removal Procedure

  1. Remove the seat back from the vehicle. Refer to Seat Back Replacement - Rear No. 1 .
  2. Remove the seat belt buckle bracket, on the right side only.
  3. Fig 1: Locating Seat Belt Anchor Bolt
    GM753723Courtesy of GENERAL MOTORS CORP.
  4. Remove the seat belt anchor bolt from the bracket.
  5. Fig 2: Identifying Plastic Retainer Buttons
    GM753729Courtesy of GENERAL MOTORS CORP.
  6. Release the seat belt bezel from the seat back by pressing in the buttons (1) on the plastic retainers.
  7. Remove the seat belt bezel by sliding it off the seat belt.
  8. Remove the head restraints. Refer to Rear Seat Head Restraint Replacement .
  9. Fig 3: View Of Latch Knob Removal
    GM753555Courtesy of GENERAL MOTORS CORP.
  10. Remove the release latch knob.
  11. Fig 4: View Of Seat Back Latch Release Bezel
    GM753553Courtesy of GENERAL MOTORS CORP.
  12. Remove the screw that retains the seat back latch release bezel to the seat back.
  13. Fig 5: View Of Bottom Of Seat Back
    GM753560Courtesy of GENERAL MOTORS CORP.
  14. Release the J-strips on the bottom of the seat back frame.
  15. Release the hook and loop retaining strips at the bottom of the seat back.
  16. Remove 3 push-pins from the bottom of the seat back.
  17. Fig 6: View Of Seat Back Pad Cover
    GM753548Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Ensure that the hook and loop retaining strips remain attached to the seat back pad.
  18. Release the cover from the hook and loop retaining strips on the front of the seat back pad.
  19. Fig 7: Locating Seat Back Push Pins
    GM753549Courtesy of GENERAL MOTORS CORP.
  20. Remove the 6 push-pins from the seat back.
  21. Remove the cover and pad from the seat back.
  22. Fig 8: View Of Cover & Pad From Seat Back
    GM753704Courtesy of GENERAL MOTORS CORP.
  23. Release the 3 hog-rings from the reinforcement bar.
  24. Remove the seat cover from the pad.