LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> Ascender RWD >> Repair and Diagnosis (Single Page) >> Body & Frame >> Exterior/Interior Trim >> Seat Hardware, Seat Trim, And Upholstery >> Repair Instructions >> Seat Back Cover and Pad Replacement - Rear No. 1 >> Installation Procedure

Installation Procedure

  1. Install the seat back pad to the seat back frame.
    2. Fig 1: Locating Seat Back Push Pins
    GM753549Courtesy of GENERAL MOTORS CORP.
  2. Install the 6 push-pins that retain the seat back pad to the seat back frame.
  3. Partially install the seat cover.
    4. Fig 2: View Of Cover & Pad From Seat Back
    GM753704Courtesy of GENERAL MOTORS CORP.
  4. Install the 3 hog-rings to the reinforcement bar.
  5. Install the seat cover the remainder of the way.
    6. Fig 3: View Of Seat Back Pad Cover
    GM753548Courtesy of GENERAL MOTORS CORP.
  6. Engage the seat cover to the hook and loop retaining strips on the seat back pad.
    7. Fig 4: View Of Seat Back Latch Release Bezel
    GM753553Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  7. Install the screw that retains the rear seat back release latch bezel to the rear seat back.

    Tighten:  Tighten the rear seat back release latch bezel screw to 3 N.m (26 lb in).

    8. Fig 5: View Of Bottom Of Seat Back
    GM753560Courtesy of GENERAL MOTORS CORP.
  8. Install the 3 push-pins at the bottom of the rear seat back.
  9. Engage the hook and loop retaining strips at the bottom of the rear seat back.
  10. Starting at either corner, engage the J-strips at the bottom of the rear seat back.
  11. Install the head restraints. Refer to Rear Seat Head Restraint Replacement .
    12. Fig 6: Identifying Buttons On Seat Belt Bezel Retainers
    GM753728Courtesy of GENERAL MOTORS CORP.
  12. Install the seat belt bezel to the rear seat back with the plastic retainers (2).
    13. Fig 7: Locating Seat Belt Anchor Bolt
    GM753723Courtesy of GENERAL MOTORS CORP.
  13. Install the rear seat belt anchor bolt into the seat belt buckle bracket.

    Tighten:  Tighten the rear seat belt anchor bolt to 55 N.m (41 lb ft).

  14. Install the seat belt buckle bracket, on the right side only.
  15. Install the seat back into the vehicle. Refer to Seat Back Replacement - Rear No. 1 .
scientia non olet · About LEMON Manuals