LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> Ascender RWD >> Repair and Diagnosis (Single Page) >> Body & Frame >> Exterior/Interior Trim >> Seat Hardware, Seat Trim, And Upholstery >> Repair Instructions >> Seat Adjuster Mechanism Replacement - Manual >> Removal Procedure

Removal Procedure

  1. Remove the front bucket seat assembly from the vehicle. Refer to Front Seat Replacement - Bucket .
  2. Remove the seat cushion trim panel. Refer to Seat Cushion Outer Trim Panel Replacement .
  3. Remove the lumbar support cable from the seat adjuster. Refer to Lumbar Support Cable Replacement .
    4. Fig 1: View Of SIR Wiring Harness Connector & Retaining Clips
    GM755831Courtesy of GENERAL MOTORS CORP.
  4. Remove the SIR harness connector (1) from the seat adjuster bracket.
  5. Remove the SIR harness from the harness clips (2) and remove the SIR harness from the seat adjuster.
  6. Remove the seat back from the seat adjuster. Refer to Seat Back Replacement - Front .
    7. Fig 2: Locating Seat Belt Buckle Nut
    GM755837Courtesy of GENERAL MOTORS CORP.
  7. Remove the seat belt buckle nut (1).
    8. Fig 3: Locating Seat Pan To Power Seat Adjuster Frame Nuts
    GM755845Courtesy of GENERAL MOTORS CORP.
  8. Remove the 4 nuts that secure the seat pan to the power seat adjuster frame.
  9. Remove the seat back. Refer to Seat Back Replacement - Front .
  10. If replacing the seat adjuster mechanism, remove the seat position sensor and retain to use on the new adjuster. Refer to Inflatable Restraint Seat Position Sensor Replacement .
scientia non olet · About LEMON Manuals