LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> Ascender RWD >> Repair and Diagnosis (Single Page) >> Body & Frame >> Exterior/Interior Trim >> Seat Hardware, Seat Trim, And Upholstery >> Repair Instructions >> Mid-Position Floor Latch Assembly Replacement - Rear No. 1 (TrailBlazer EXT, Envoy XL) >> Removal Procedure

Removal Procedure

  1. Remove the seat from the vehicle. Refer to Rear Seat Replacement .
  2. Remove the trim panel from the seat cushion. Refer to Seat Cushion Trim Panel Replacement - Rear No. 1 (TrailBlazer EXT, Envoy XL) .
  3. Remove the rear center seat belt buckle assembly from the floor latch assembly. Refer to Seat Belt Buckle Replacement - Center Rear .
    4. Fig 1: Identifying Mid-Position Floor Latch Assembly Components
    GM828232Courtesy of GENERAL MOTORS CORP.
  4. Remove the cable (3) from the mid-position floor latch assembly (2).
  5. Remove the bolts (1) securing the mid-position floor latch assembly to the seat cushion frame.
  6. Remove the mid-position floor latch assembly.
scientia non olet · About LEMON Manuals