LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> Ascender RWD >> Repair and Diagnosis (Single Page) >> Body & Frame >> Exterior/Interior Trim >> Seat Hardware, Seat Trim, And Upholstery >> Repair Instructions >> Head Restraint Retractor Assembly Replacement - Rear No. 1 >> Removal Procedure

Removal Procedure

    CAUTION: Refer to SEAT BELT SERVICE PRECAUTIONS to prevent accidental deployment of the head restraint retractor assembly.
  1. Remove the seat back cover and pad. Refer to Seat Back Cover and Pad Replacement - Rear No. 1 .
    2. Fig 1: Identifying Head Restraint Retractor Assembly To Seat Back Frame Bolts
    GM753545Courtesy of GENERAL MOTORS CORP.
  2. Remove the 3 bolts that retain the head restraint retractor assembly to the seat back frame.
    3. Fig 2: Aligning Head Restraint Retractor Assembly
    GM753546Courtesy of GENERAL MOTORS CORP.
  3. Partially remove the head restraint retractor assembly from the frame.
    4. Fig 3: View Of Release Cable In Head Restraint Retractor Assembly Access Hole
    GM753547Courtesy of GENERAL MOTORS CORP.
  4. Remove the release cable by sliding the cable retainer over to the large access hole and removing the cable from the head restraint retractor assembly.
  5. Remove the retractor assembly from the seat back frame.
scientia non olet · About LEMON Manuals