LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> Ascender RWD >> Repair and Diagnosis (Single Page) >> Body & Frame >> Exterior/Interior Trim >> Seat Hardware, Seat Trim, And Upholstery >> Repair Instructions >> Front Seat Back Cover and Cushion Pad Replacement >> Removal Procedure

Removal Procedure

    Fig 1: Identifying Seat Belt Bezel Retaining Screw
    GM752860Courtesy of GENERAL MOTORS CORP.
  1. Adjust lumbar to a relaxed position.
  2. Remove the front seat assembly from the vehicle. Refer to Front Seat Replacement - Bucket .
  3. Remove the seat pad trim panel. Refer to Seat Cushion Outer Trim Panel Replacement .
  4. Remove the head restraint. Refer to Front Seat Head Restraint Replacement .
  5. Remove the screw that retains the seat belt bezel to the top of the seat back.
    6. Fig 2: Identifying Seat Cover, J Strips & Pushpins
    GM752846Courtesy of GENERAL MOTORS CORP.
  6. Release the J-strips (1, 4) across the bottom of the seat back cover.
  7. Remove the push-pins (3) securing the seat cover (2) to the seat frame.
  8. Release the J-strips (1, 4) across the bottom of the seat back cover.
    9. Fig 3: Locating Seat Back Cover Retaining Strips
    GM752854Courtesy of GENERAL MOTORS CORP.
  9. Using a flat-bladed tool, carefully disengage the plastic strips that retain the seat back cover to the side air bag inflator module cover.
  10. Carefully remove the seat back cover from behind the trim edge of the side air bag inflator module.
    11. Fig 4: Aligning Seat Cover On Lower Seat Back Pad
    GM752842Courtesy of GENERAL MOTORS CORP.
  11. Compress the seat back pad in order to relieve the pressure against the seat cover.
  12. Using a side-to-side motion, carefully lift off the seat back cover, partially separating the seat back cover from the foam pad.
    13. IMPORTANT: When separating the seat cover hook and loop retaining strips, do not pull the adhesive-backed strip from the pad.
  13. Release the lower velcro retaining strips located inside the seat cover.
  14. Remove the 3 hog rings that retain the seat back pad to the reinforcement bar located at the top of the seat back.
    15. Fig 5: Identifying Head Restraint Guides
    GM752738Courtesy of GENERAL MOTORS CORP.
  15. Spread the pad apart and push the cover and pad up over the seat back in order to expose the head restraint guides.
  16. Remove the head restraint guides by squeezing the locking tabs together and pulling the restraint guides upward and out of the seat frame.
  17. Remove the seat back cover the remainder of the way from the seat back.
  18. Disconnect the electrical connector for the seat back heating element, located near the seat belt retractor, if equipped.
  19. Carefully remove the seat back pad from the seat back frame.
scientia non olet · About LEMON Manuals