LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> Ascender RWD >> Repair and Diagnosis (Single Page) >> Body & Frame >> Exterior/Interior Trim >> Seat Hardware, Seat Trim, And Upholstery >> Repair Instructions >> Front Seat Back Cover and Cushion Pad Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Identifying Head Restraint Guides
    GM752740Courtesy of GENERAL MOTORS CORP.
  1. Position the seat back pad to the seat back frame.
  2. Connect the electrical connector to the seat back heating element, if equipped.
  3. Partially install the seat back cover over the top of the seat.
  4. Install the head restraint guides to the seat frame. Ensure that the locking tabs are fully seated. The guide with the release tab goes on the right-hand side.
    5. Fig 2: Aligning Seat Cover On Lower Seat Back Pad
    GM752842Courtesy of GENERAL MOTORS CORP.
  5. Pull the seat back cover down approximately 18 cm (7 in) from the top of the seat back, leaving the reinforcement bar exposed.
  6. Install the hog rings that retain the seat back pad to the reinforcement bar.
  7. Pull the seat cover over the seat back pad.
  8. Press the seat cover hook and loop retaining strips together by firmly running your hand over the seat back cover.
    9. Fig 3: Identifying Seat Belt Bezel Retaining Screw
    GM752860Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  9. Install the seat belt bezel to the top of the seat back with the mounting screw.

    Tighten:  Tighten the seat belt bezel screw to 3 N.m (26 lb in).

    10. Fig 4: Locating Seat Back Cover Retaining Strips
    GM752854Courtesy of GENERAL MOTORS CORP.
  10. Using a flat-bladed tool, carefully engage the plastic strips that retain the seat back cover to the side air bag inflator module.
  11. Carefully install the seat back cover behind the trim edge of the side air bag inflator module.
    12. Fig 5: Identifying Seat Cover, J Strips & Pushpins
    GM752846Courtesy of GENERAL MOTORS CORP.
  12. Fasten the J-strips (1, 4) across the bottom of the seat back cover.
  13. Install the seat cover flaps (2) to the seat frame with push-pins (3).
  14. Install the seat trim panel. Refer to Seat Cushion Outer Trim Panel Replacement .
  15. Install the head restraint. Refer to Front Seat Head Restraint Replacement .
  16. Install the front seat assembly from the vehicle. Refer to Front Seat Replacement - Bucket .
scientia non olet · About LEMON Manuals