Removal Procedure

Fig 1: View Of Grille Emblem (TrailBlazer LT)

GM1774004

Courtesy of GENERAL MOTORS CORP.

When replacing or repairing an emblem/nameplate do the following:
1. Use tape to protect the mounting surface during removal.
2. Use tape for alignment marks for installation of the emblem/nameplate.
To remove an emblem/nameplate, heat the emblem/nameplate using a heat gun. Apply heat using a circular motion for about 30 seconds.

Fig 2: Identifying Adhesive Removal Tool

GM321645

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to EXTERIOR TRIM EMBLEM REMOVAL NOTICE .

Use a plastic, flat-bladed tool to remove the emblem/nameplate from the panel surface.
When replacing, remove all adhesive as follows:
- For body panels use a 3M™ Scotch Brite molding adhesive remover disk 3M™ P/N 07501 or equivalent.
- For plastic panels use a lint-free cloth and Varnish Makers and Painters (VMP) naptha or a 50/50 mixture by volume of isopropyl alcohol and water to remove the adhesive.