LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> Ascender RWD >> Repair and Diagnosis (Single Page) >> Body & Frame >> Exterior/Interior Trim >> Exterior Trim >> Repair Instructions >> Grille Replacement (Envoy) >> Removal Procedure

Removal Procedure

    Fig 1: View Of Grille (Envoy, Envoy XUV)
    GM740799Courtesy of GENERAL MOTORS CORP.
  1. Use a flat-bladed tool in order to release the clips that retain the top of the grille (2) to the headlamp housing panel.
  2. Lift the grille (2) out of position.
  3. Release the quick-connect (4) on the headlamp washer supply hose.
  4. Remove the grille from the vehicle.
  5. Place the grille on a clean, prepared surface.
    6. Fig 2: View Of Washer Nozzles From Grille (Envoy, Envoy XUV)
    GM740800Courtesy of GENERAL MOTORS CORP.
  6. Release the quick-connects (3) on the headlamp washer nozzle hoses.
  7. Spread the retaining tabs (1) on the grille in order to release the headlamp washer nozzle.
  8. Remove the headlamp washer nozzle from the front of the grille.
  9. Remove the headlamp washer hose (4) from the grille.
scientia non olet · About LEMON Manuals