LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> Ascender RWD >> Repair and Diagnosis (Single Page) >> Body & Frame >> Exterior Body Panels >> Bumper System & Fascia >> Repair Instructions >> Rear Bumper Step Pad Replacement (TrailBlazer) >> Installation Procedure

Installation Procedure

  1. Remove the backing from the adhesive strips.
  2. Position the step pad to the fascia.
  3. Install the step pad to the fascia, ensuring that the retaining tabs are thoroughly engaged, and the end of the step pad are secured.
    4. NOTE: Refer to Fastener Notice .
  4. Install the bolts.

    Tighten:  Tighten the step pad retaining bolts to 10 N.m (89 lb in).

scientia non olet · About LEMON Manuals