LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> Ascender RWD >> Repair and Diagnosis (Single Page) >> Body & Frame >> Exterior Body Panels >> Bumper System & Fascia >> Repair Instructions >> Rear Bumper Step Pad Replacement (Envoy, Rainier) >> Removal Procedure

Removal Procedure

    NOTE: When removing body panels, apply tape to corners of panel and adjacent surfaces to help prevent paint damage.
  1. Apply protective tape to the bumper surface at the edge of the step pad.
  2. Open the liftgate.
    3. Fig 1: Releasing Step Pad
    GM308181Courtesy of GENERAL MOTORS CORP.
  3. Use a flat-bladed tool to release the step pad from the adhesive strips located at each end of the step pad.
    4. Fig 2: View Of Rear Door Body Panel
    GM755560Courtesy of GENERAL MOTORS CORP.
  4. Release the step pad retaining tabs.
  5. Remove the step pad from the fascia.
  6. Remove all adhesive from the rear bumper fascia using 3M™ ScotchBrite molding adhesive remover disk 3M™ P/N 07501 or equivalent.
  7. Clean the rear bumper fascia surface using Varnish Makers and Painters (VMP) naphtha and allow to air dry.
scientia non olet · About LEMON Manuals