LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> Ascender RWD >> Repair and Diagnosis (Single Page) >> Body & Frame >> Exterior Body Panels >> Bumper System & Fascia >> Repair Instructions >> Rear Bumper Step Pad Replacement (Envoy, Rainier) >> Installation Procedure

Installation Procedure

    Fig 1: View Of Rear Door Body Panel
    GM755560Courtesy of GENERAL MOTORS CORP.
  1. Remove the backing from the adhesive strips.
  2. Position the step pad to the fascia.
  3. Install the step pad to the fascia, ensuring that the retaining tabs are thoroughly engaged, and the end of the step pads are secured.
  4. Close the liftgate.
scientia non olet · About LEMON Manuals