LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> Ascender RWD >> Repair and Diagnosis (Single Page) >> Body & Frame >> Exterior Body Panels >> Bumper System & Fascia >> Repair Instructions >> Rear Bumper Impact Bar Replacement >> Removal Procedure

Removal Procedure

  1. Remove the spare tire carrier. Refer to Tire Hoist and Shaft Replacement .
  2. Remove the rear fascia. Refer to Rear Bumper Fascia Replacement .
    3. Fig 1: View Of Trailer/Towing Receptacle Electrical Connector
    GM752485Courtesy of GENERAL MOTORS CORP.
  3. Disconnect the trailer/towing receptacle electrical connector.
  4. Rotate the trailer/towing receptacle assembly counterclockwise and remove from the vehicle.
    5. Fig 2: View Of Impact Bar And Rearward Bolts
    GM752281Courtesy of GENERAL MOTORS CORP.
  5. Remove the 4 rearward bolts that retain the impact bar assembly to the frame rails.
  6. While an assistant holds the impact bar (1) assembly in place, remove the remaining 2 retaining bolts.
  7. Remove the impact bar (1) assembly from the vehicle with an assistant.
scientia non olet · About LEMON Manuals