LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> Ascender RWD >> Repair and Diagnosis (Single Page) >> Body & Frame >> Exterior Body Panels >> Bumper System & Fascia >> Repair Instructions >> Rear Bumper Impact Bar Replacement >> Installation Procedure

Installation Procedure

    Fig 1: View Of Impact Bar And Rearward Bolts
    GM752281Courtesy of GENERAL MOTORS CORP.
  1. Position the impact bar (1) assembly to the vehicle with an assistant.
    2. NOTE: Refer to FASTENER NOTICE .
  2. Install the bolts that retain the rear impact bar to the frame.

    Tighten:  Tighten the rear impact bar bolts to 364 N.m (268 lb ft).

    3. Fig 2: View Of Trailer/Towing Receptacle Electrical Connector
    GM752485Courtesy of GENERAL MOTORS CORP.
  3. Install the trailer/towing receptacle assembly to the bracket and rotate clockwise until fully seated.
  4. Connect the trailer/towing receptacle electrical connector.
  5. Install the rear fascia. Refer to Rear Bumper Fascia Replacement .
  6. Install the spare tire carrier. Refer to Tire Hoist and Shaft Replacement .
scientia non olet · About LEMON Manuals