LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> Ascender RWD >> Repair and Diagnosis (Single Page) >> Body & Frame >> Exterior Body Panels >> Bumper System & Fascia >> Repair Instructions >> Rear Bumper Fascia Replacement >> Removal Procedure

Removal Procedure

  1. Remove the backup lamp socket assemblies from the backup lamp housings, if applicable. Refer to Backup Lamp Replacement (GMC) .
    2. Fig 1: View Of Lower Fascia Push-Pins
    GM743497Courtesy of GENERAL MOTORS CORP.
  2. Remove the lower fascia push-pins.
    3. Fig 2: View Of Screws To Rear Wheelhouse Flanges
    GM743499Courtesy of GENERAL MOTORS CORP.
  3. Remove the screws from the rear wheelhouse flanges.
    4. Fig 3: View Of Fascia And Upper Retaining Bolts
    GM743498Courtesy of GENERAL MOTORS CORP.
  4. Remove the upper retaining bolts from the back of the fascia.
  5. Remove the fascia from the vehicle.
scientia non olet · About LEMON Manuals