LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> Ascender RWD >> Repair and Diagnosis (Single Page) >> Body & Frame >> Exterior Body Panels >> Bolted Exterior Body Panels And Closures >> Repair Instructions >> Liftgate Strut Replacement >> Removal Procedure

Removal Procedure

CAUTION: When a hood hold open device is being removed or installed, provide alternate support to avoid the possibility of damage to the vehicle or personal injury.
  1. Open and support the liftgate.
    NOTE: Refer to LIFTGATE ASSIST ROD NOTICE .
    2. Fig 1: View Of Liftgate Strut Locations
    GM721370Courtesy of GENERAL MOTORS CORP.
  2. Lift up the retainer clips on the liftgate struts using a small flat-bladed tool.
  3. Remove the upper end of the liftgate struts from the ball joint.
  4. Remove the lower end of the liftgate struts from the ball joint.
  5. Remove the liftgate struts from the liftgate.
scientia non olet · About LEMON Manuals