LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> Ascender RWD >> Repair and Diagnosis (Single Page) >> Body & Frame >> Exterior Body Panels >> Bolted Exterior Body Panels And Closures >> Repair Instructions >> Liftgate Hinge Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Identifying Body Side Hinge Retaining Nuts
    GM1344402Courtesy of GENERAL MOTORS CORP.
  1. Install the body side hinges (1) to the body.
    2. NOTE: Refer to Fastener Notice .
  2. Install the nuts retaining the body side hinges to the body.

    Tighten:  Tighten the body side hinge nuts to 20 N.m (15 lb ft).

    3. Fig 2: Identifying Body Side Hinge Pivots & Bushings
    GM1344406Courtesy of GENERAL MOTORS CORP.
  3. Install the hinge pivots (1) to the body side hinges.
  4. Install the hinge bushings (2) to the body side hinges.
    5. Fig 3: Identifying Liftgate Hinge Bushings & Pivots
    GM1344405Courtesy of GENERAL MOTORS CORP.
  5. Install the hinge bushings (1) to the liftgate hinges.
  6. Install the hinge pivots (2) to the liftgate hinges.
    7. Fig 4: Identifying Liftgate Hinge Pivot Retainers
    GM1344407Courtesy of GENERAL MOTORS CORP.
  7. With the aid of an assistant, install the liftgate to the body side hinge by inserting the hinge pivots into the hinge bushings and sliding the liftgate to the right.
  8. Install the liftgate hinge pivot retainers (1) to the liftgate hinge pivots.
  9. Connect the liftgate to the body wiring harness connector. Refer to Liftgate Wiring Harness Replacement .
  10. Install the liftgate struts. Refer to Liftgate Strut Replacement .
  11. Install the liftgate window. Refer to Liftgate Window Replacement .
scientia non olet · About LEMON Manuals