LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> Ascender RWD >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Steering Column Switches >> Steering Wheel & Steering Column >> Repair Instructions >> Steering Column Wire Harness Assembly Replacement >> Removal Procedure

Removal Procedure

    Fig 1: View Of Upper And Lower Trim Covers
    GM761444Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to SIR Caution .
  1. Disable the SIR system. Refer to SIR Disabling and Enabling .
  2. Remove the upper and lower trim covers. Refer to Steering Column Trim Covers Replacement .
  3. Remove the wire harness strap.
    4. Fig 2: Identifying Key Alarm Connector At Ignition Lock Cylinder Case
    GM306267Courtesy of GENERAL MOTORS CORP.
  4. Remove the steering wheel theft deterrent lock. Refer to Steering Wheel Theft Deterrent Lock Replacement .
  5. Rotate the key alarm connector (1) 90 degrees.
  6. Gently pull the key alarm connector (1) out of the ignition lock cylinder case assembly (2).
  7. Disconnect the connector from the ignition switch assembly.
  8. Remove the wires encased in the ignition switch clip, which is located on the side of the ignition switch.
    9. Fig 3: View Of Steering Column And Wire Harness Assembly
    GM603937Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: If the steering wheel has steering wheel controls, the SIR coil and the wire harness assembly must come off as one piece. Refer to Inflatable Restraint Steering Wheel Module Coil Replacement .
  9. Disconnect all connectors attached to the wire harness assembly.
scientia non olet · About LEMON Manuals