LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> Ascender RWD >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Steering Column Switches >> Steering Wheel & Steering Column >> Repair Instructions >> Steering Column Seal Replacement >> Installation Procedure

Installation Procedure

  1. Install steering column seal by rolling seal lip to inside vehicle.
    2. Fig 1: View Of Steering Column To Steering Gear Connection
    GM687445Courtesy of GENERAL MOTORS CORP.
  2. Connect the lower intermediate shaft to the upper intermediate shaft.
    3. NOTE: Refer to Fastener Notice .
    IMPORTANT: Perform the following procedure before installing the bolt.
    1. Remove all traces of the original adhesive patch.
    2. Clean the threads of the bolt with denatured alcohol or equivalent and allow to dry.
    3. Apply threadlocker GM P/N 12345382 (Canadian P/N 10953489) or LOCTITE™ 222.
  3. Install the lower intermediate shaft to the upper intermediate shaft pinch bolt.

    Tighten:  Tighten the lower intermediate shaft to the upper intermediate shaft pinch bolt to 50 N.m (37 lb ft).

    4. IMPORTANT: The upper intermediate shaft boot must completely cover the white insert of the lower intermediate shaft boot to ensure proper sealing.
  4. Connect the upper intermediate shaft boot to the lower intermediate shaft boot.
    5. Fig 2: Identifying J 42640
    GM333146Courtesy of GENERAL MOTORS CORP.
  5. Unlock the steering column by removing J 42640  from the steering column lower trim cover access hole. See Special Tools .
scientia non olet · About LEMON Manuals