LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> Ascender RWD >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Seats >> Seat Hardware, Seat Trim, And Upholstery >> Repair Instructions >> Seat Cushion Outer Trim Panel Replacement >> Installation Procedure

Installation Procedure

  1. Install the trim panel to the power seat by performing the following steps:
      Fig 1: View Of Trim Panel Retaining Screws Removed (Right)
      GM752954Courtesy of GENERAL MOTORS CORP.
    1. Align the trim panel to the seat assembly.
      2. NOTE: Refer to Fastener Notice.
    2. Install the screws retaining the trim panel to the seat assembly.

      Tighten:  Tighten the trim panel screws to 3 N.m (26 lb in).

    3. Install the 3 seat switch bezel mounting screws.

      Tighten:  Tighten the seat switch bezel mounting screws to 3 N.m (26 lb ft).

  2. Install the trim panel to the manual seat by performing the following steps:
      Fig 2: View Of Trim Panel Retaining Screws Removed (Left)
      GM755843Courtesy of GENERAL MOTORS CORP.
    1. Install the screws in the trim panel.
    2. Install the lumbar support knob. Refer to Lumbar Support Knob Replacement .
    3. Install the seat back recliner handle. Refer to Seat Back Recliner Handle Replacement - Front .
scientia non olet · About LEMON Manuals