LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> Ascender RWD >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Seats >> Seat Hardware, Seat Trim, And Upholstery >> Repair Instructions >> Seat Back Release Latch Replacement - Rear No. 1 >> Installation Procedure

Installation Procedure

    Fig 1: Locating Release Cable At Release Latch
    GM753552Courtesy of GENERAL MOTORS CORP.
  1. Install the release cable to the release latch.
    2. Fig 2: Compressing Lower Locking Tabs On Release Latch
    GM753536Courtesy of GENERAL MOTORS CORP.
  2. Install the release latch to the seat frame by pressing the latch into the seat frame until the locking tabs are fully engaged.
  3. Install the seat back cover and pad. Refer to Seat Back Cover and Pad Replacement - Rear No. 1 .
scientia non olet · About LEMON Manuals